View Full Version : Particle generator questions
September 30th, 2009, 11:37 AM
Hi, how do i assign a different image to a particle thats generated? What i have is a particle emitter attached to a light and use a image as particle, what i want to do is to use a clip with different images and that each particle generated is different, i can do this by duplicating the particle setup and assigning a different image to each one, but there are more than 30 images and want to it in one pass.
October 1st, 2009, 06:47 AM
depends on the software you use... but as a general if every frame a particle is born, then the source image for the particle texture should change, and that means renaming the textures so that the software recognizes them as a sequence and change the textures every frame :)
October 1st, 2009, 12:52 PM
Well, just finishing the proyect, in one scene i had to add a lot of particle emitters and now i have a 30 minutes render instead of a 5 min wich was before i did this, its 48 frames in SD!!